Checking the "Enable advanced options in modules" box in the Settings module will result in additional options to be accessible to the user across different modules of AccessMod, as shown in the information reported in the following table:
Module/tool | Section | Advanced option | Description |
|---|---|---|---|
Data | Filter | Show internal data check button | Checking this button will make several types of internal data sets visible to the users (e.g., "friction", "speed", and "landcover merged bridge" raster data sets) in the "Available Data" table. See below for an explanation of these data sets. |
Toolbox | Roads tab | Show checkbox to "Do not add 1000 to class < 1000" | If this button is checked, the values of the road categories (if <1000) will be kept as they are defined in the road layer (and 1000 will not be added to these categories) |
Accessibility | Analysis settings | Optimize dynamically computation according to the scenarioThis option | limits the computation zone around the current facility. A buffer is first created around the facility, using with the fastest speed of the defined scenario. The footprint of this buffer is then user to crop the mergelandcover, so that the computation is done using a much smaller grid. This can drastically reduce the computation timeUsing this option can drastically decrease the computation time, particularly when the number of cells is large, that is when the extent of the zone is large and at high resolution. The optimisation procedure clips all raster around each facility, with clip surfaces corresponding to the maximum surface of a catchment that would be computed by using the largest speed found in the travel scenario and applied everywhere. It is recommended to use this option with the geographic coverage analysis. |
Accessibility | Analysis settings | Save analysis parameters without computing | This option is used to prepare the analysis and its configuration file which is then saved, but the analysis is not executed. The configuration file can then be used with the Replay mode. |
Accessibility | Analysis settings | Use 'floor' rounding when converting travel time from seconds to minutes | Historically, AccessMod uses a floor function to convert travel times from seconds to minutes (i.e., 59.9 min → 59 min) to have the travel time rasters s integer raster. This had to be changed to a ceiling function from version 5.8 onward. The default behaviour is now 59.9 min → 60 min. If this floor rounding option is checked, the behaviour gets back to the historical use of the floor function. |
Accessibility | Analysis settings | Compute a cost allocation layer | This option computes the cost allocation raster layer, a raster that contains the unique id of the nearest health facility by time (stored in the VALUE field). This unique id corresponds to the information stored in the 'cat' column of the health facility layer exportable from the 'Data' module. The class for this raster is named "cost allocation". |
...